OFF is the normal boot state, the red LED is lit as well as the green. Putting 12 VDC to them at the enable signal turns them OFF. Find best value and selection for your Bridgeport EZ TRAK SX Programming Operations Manual search on eBay. Bridgeport Machines - Vertical Milling Machine - Discovery 308-SX., 1990, Milling Machines, Bridgeport Machines - Series I EZ-TRAK PLUS, 2, Thomas, Paul., Unknown, Milling Machines, Bridgeport Series M105H Manual. The green on the drives means they have power.ģ1, 2011, Milling Machines, Bridgeport J-Head Series I Mill Rebuild, 69. The two red lights go off when the BMDC loads its software (actually one glows a little bit). Has the CMOS battery (ni-cad) ever been changed? It may have leaked and eaten away at the deposited wires on the mother board. If it does not access the floppy at least for a few seconds during start up, then the motherboard is dead or does not know it has a floppy (check CMOS). Getting green light on motor drive modules but nothing on monitor. When booting up I do not see the light go on on floppy disk drive. What I think is the BMDC card has 2 red light which are on. Moved video board to different slot -did not help. Checked power supply getting approx 3v on 5v output. Machine would shut down by it's self, and not boot up sometimes. Ez track sx problem: started out as loss of display.
0 Comments
Leave a Reply. |